Identify the colour code and surface: Identify the vinyl floor type through the surface. The currently produced surfaces are: antique wood texture (BP pattern), hand scrape (hand scratch pattern), crystal (crystal surface), EIR ( Synchronize the flowers; see the following table:

No. Surface - Order Uniform Name English Name - External Uniform Applicable Size (width is 1m)
1 BP Antique wood texture 1 meter, 1.3 meters

2 Crystal 1 meter, 1.3 meters
3 Carpenter handscrape 1 meter, 1.3 meters

4 Flowers are out of sync 201207 EIR-201207 1.3 meters
5 synchronised embossing 8229 EIR-8229 1 meter

6 synchronised embossing 6092 EIR-6092 1 Meter
7 synchronised embossing 6196 EIR-6196 1.3 Meters
8 Classic Slate 1.3 m
9 Pearl Structure 1.3 meters
10 Granite texture 1.3 m
The color can be distinguished by the tree species. Press-fit workshop steel plate pattern: In addition to BP pattern, hand-grip board, crystal surface, flower (color film and steel pattern), flowers are not synchronized, there are slate pattern, pearl pattern. There are two sizes of steel plate: 1X1m, 1X1.3m. The effect of matt film and soft film is similar, soft film is a substitute for matt film. Matte film is relatively hard, white and Mongolian color, usually at the bottom of the floor, soft film, very soft, relatively bright. In general, hard-to-press membranes are used for soft membranes. The soft membranes are expensive, inexpensive, and can prevent escape (color disappears or discolors, hazy); the matt film controls brightness and tension. There are many kinds of color film, such as woodgrain, carpet pattern, stone pattern, etc. According to the customer's requirements, different types of color film can be purchased. The vinyl plank floor can be used to reinforce the same texture and color as the floor, but it can have the laminate flooring. Completely unachievable water resistance and super wear resistance, the most surface layer is wear-resistant layer, thickness from 0.07 --- 1.0mm range, the degree of wear is naturally different. Generally speaking, 0.3mm is the boundary, is the distinction Commercial and domestic standards. In general, the wear resistance of plastic floor is higher than that of other floors. Under the abrasion resistance test of CS-17 grinding wheel, the 1.0 mm thickness of wear-resistant floor can reach 20,000 rpm. Hand-grained grained steel plate, not 0.1mm wear layer, deeper lines, 0.1mm wear layer is easily damaged when hot-pressed, it is recommended to use at least 0.2mm wear layer. Wear layer thickness specifications are 0.1, 0.15, 0.2, 0.3, 0.5, 0.7, in mm, wear layer thickness requirements are generally 0.1mm-1.0mm, the current market is the highest to 0.7mm, usually 0.5mm.